![]() If you have any questions or suggestions, please feel free to leave a comment below.An excellent headphone should have a durable design and should be able to reproduce low bass notes as well as high treble notes without distortion. Usually, a hard factory reset can do the job for a soft-bricked Anker speaker. I hope that this article was helpful in identifying and trying to fix the issue of an Anker Soundcore Speaker not charging. In this case, you might have to take it to the service center for repair. If the charging light does not turn on and the speaker is not charging, then there might be some water damage, especially when you have recently taken them to the pool or shower. Though Soundcore Speakers have basic protection against water ingression, it’s still a good idea to check for water damage. Or you can simply blow air into the port to remove the dirt.īe very careful while doing so as you can accidentally damage the charging port. In this case, you can try to clean it using a toothpick or a needle. The charging port may have some dirt or lint inside that is preventing the speaker from charging. When the reset process is complete, you would most probably be able to charge your SoundCore speaker. If you are not sure about the process, I have dedicated a separate post to it where the reset process of all Soundcore speakers is discussed in detail. Now, press the Bluetooth button for 3 seconds to delete records for all paired devices. To factory reset your Soundcore Speaker, Press and hold the power button for at least 10 sec. ![]() It should be your last resort and only applied when you’ve tried everything else and the speaker is still not charging. Perform a Factory Reset to Wipeout All the Data:įactory or hard resetting your Soundcore speaker will delete all of your personal data and settings. I would recommend you to have the battery checked by a technician, and if that is the culprit, have your Bluetooth speaker replaced at the service center. In other cases, overcharging or exposure to heat damages the battery beyond repair. Over time, lithium-ion batteries tend to lose their charging capacity, until they are completely dead. If your Soundcore Speaker is not brand new and you have been using it for some time now, the battery might be the issue. If that still doesn’t work, then the problem might be with the speaker itself. If it does not charge, then the problem might be with the charger. If it charges with a different cable, then the problem is with the original USB cable. ![]() To do that, try charging your Soundcore speaker with a different USB cable. A defective or faulty USB cable can cause all sorts of problems, so it’s always a good place to start. The very first step is to identify if the problem is with the speaker or the charger. Steps to Fix Anker Soundcore Speaker Not Charging: Try Using a different Charging Cable or Power Adaptor:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |